2nd motor back from propinch

[Czech-it-Out Graphics]

not many do, alot of times if you are sponsored you can send in your used shit an they will rebuild it for you either for free or pretty cheap. But when my dad had the access to the machines to do pinching i pinched them light until they just didnt run as well. At that point most of my motors had 10 gallons on them so they were for parts or to sell with a roller on ebay. Usually the bearings are good and the case is always good to have for back up etc. pinching is pretty much ur best bet, break it in again (lightly) then after about a gallon or so throw in a new rod and it will last you a long time