02-22-2006, 08:21 PM
mikecooper Wrote:I just went to use my maxx after fixing the receiver problems, and it drove maybe 20 feet, then just revved, my spur gear is grinded down now I have to buy a new one at Al's, that is if they have any, and find out how to replace the thing on the maxx.
You need to know how to replace it? Take the tank and motor off, the undo the nut take the gear off replace it, then put the motor and tank back in, take a piece of paper put it in between the spur gear and the clutch bell and gently push the motor towards the spur (center) Tighten down the motor screws on the bottom of the truck while still gently pushing the motor toward the spur, and then take the paper out and roll the truck to make sure that the mesh is good, if it is making like a grinding noise it is too tight, if it is super easy to roll it might be too loose you might want to move it a little bit to the center.
8ight | Mini-T | CEN Boat | Stampede | JR R-1
ALL RC STUFF FOR SALE. PM FOR DETAILS.
ALL RC STUFF FOR SALE. PM FOR DETAILS.