Posts: 1,330
Threads: 91
Joined: Nov 2005
Reputation:
0
Im just starting to break this motor in but when i go to lean out the highspeed needle it is very tight and hard to turn is this normal?
Mugen MBX5T Prospec
RB C6bb/O.S. Speed
Hitec 5955
Futaba s9351
Jr Z-1
http://www.frontlinetec.com
Soo easy a cave man can drive it Mooooooooooogen
Posts: 13,181
Threads: 169
Joined: Jul 2004
Reputation:
0
Novas have very VERY stiff needles... Normal
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune
Posts: 9,001
Threads: 126
Joined: Jul 2004
Reputation:
0
my p5 is like that too.
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Posts: 1,330
Threads: 91
Joined: Nov 2005
Reputation:
0
alright cool, im using the heat cyle method doing- these are in mins 3 mins cool down 3 mins cool down up to 15 mins at 200 degrees then bump up to 4 mins then cool down until i have reached 25 mins then ill start tuning for race.
Mugen MBX5T Prospec
RB C6bb/O.S. Speed
Hitec 5955
Futaba s9351
Jr Z-1
http://www.frontlinetec.com
Soo easy a cave man can drive it Mooooooooooogen
Posts: 826
Threads: 14
Joined: Apr 2005
Reputation:
0
just make sure you are at least at 200 deg. every time
TEAM DENTTEK HACKING OUR WAY TO THE TOP!!!!!!
THE ANGRY PEAR IS BACK
Posts: 1,330
Threads: 91
Joined: Nov 2005
Reputation:
0
I was between 200-220 everytime there was one time that i was at about 190 but i put a sock on the motor to keep the engine temps up. Kina nippy out today.
Mugen MBX5T Prospec
RB C6bb/O.S. Speed
Hitec 5955
Futaba s9351
Jr Z-1
http://www.frontlinetec.com
Soo easy a cave man can drive it Mooooooooooogen
Posts: 13,181
Threads: 169
Joined: Jul 2004
Reputation:
0
Take your time. That engine has a cnc'd pistion. Its not cast like all other engines. Seriously strong
Dont mess wit my sig Line tune!
--Then follow the rules! haha!-- -Tune