08-21-2007, 02:22 PM
get some air seal from RE, i believe TKO has it in stock. take of the back plate put some seal evenly on the parts that come in contact with the block only, so a couple mm from the edge of the backplate, do the same on the carb, put some seal on the neck of the carb around the outside and cover the two sides of the pinch bolt with it
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"