07-12-2007, 09:22 PM
That's the edge there referring to. If you take 2 cup and hold them together at that edge you may see the imperfection of the mold. Assuming the gears are perfectly flat, you'd want the mounting surface of the cup to be flat also to have a good seal. put that sandpaper down on something flat like glass or a mirror and sand the cups in a figure eight till you can see the cup has been sanded around the whole circumference of the sealing edge.
As for the linkage, depending which servo horns you use (I used the sportwerks throttle brake horn) you mount the brake linkage on the outside holes so the rods are at a slight angle clearing that splash shields.
As for the linkage, depending which servo horns you use (I used the sportwerks throttle brake horn) you mount the brake linkage on the outside holes so the rods are at a slight angle clearing that splash shields.
MBX5T - O.S.
MBX5R - Novarossi
Nomadio