04-18-2007, 07:55 PM
rcrunr1 Wrote:yes, I use blue loctite on the clutch nut, just a little as said before. Just be sure to get it good and tight against the flywheel so it cinches up against the collet. I also use the piston-locking-tool-thing that goes though the backplate to capture the con rod so it can't rotate in the cylinder. I think its made by Dynamite. Cheap tool and it works!!
cheap tool that damages ur piston...
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"