Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Crt .5
#1
Does the CRT.5 take regular 1/10th-1/8th size servos?
Does it use a standard RX hump?
Will it start w/ the Chrome top starter box I use for my CRT?
Any .12 engine??
Jammin' CRT, BCE j2pro, Nova p5x, Fioroni pipe
I was born under the hood of a 68 FastBack, Synthetic 10w-30 in my veins, 120 octane in my bottle, Nitrous Oxide for adrenalin and a Blower for a soother
Reply
#2
It takes servos smaller than normal
I think it comes with a hump pack that consists of AAA's
Not sure about starter box, probably will work
any .12 engine with a SG shaft (pilot shaft)
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#3
bradley runs a TZ in his
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#4
Tex Wrote:It takes servos smaller than normal
I think it comes with a hump pack that consists of AAA's
Not sure about starter box, probably will work
any .12 engine with a SG shaft (pilot shaft)

Where does one get smaller than normal servos?

Czech-it-Out Graphics Wrote:bradley runs a TZ in his

I'd probably run one as well...When I made the thread I thought a .18 wouldn't mount into somthing that fitted a .12, I was wrong Smile
Jammin' CRT, BCE j2pro, Nova p5x, Fioroni pipe
I was born under the hood of a 68 FastBack, Synthetic 10w-30 in my veins, 120 octane in my bottle, Nitrous Oxide for adrenalin and a Blower for a soother
Reply
#5
I think Chad Bradley runs the .12TZ, not .18 although I could be wrong.

The .18 should fit if you really want to go that route but it would be seriously over powered. Actually I've seen a video of a .5 with a .18tz and all it did was wheelie all over the place... even with the diffs setup to race
Mugen MBX5T
RBS5
RB2045
Futaba 3PM
Hitec 5955, 5965
Reply
#6
I can start my inferno 09 on my bump box, 1/8th offroad box.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)