+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Main Forums (https://www.chitownrc.com/forum-4.html)
+--- Forum: Racers Forum (https://www.chitownrc.com/forum-9.html)
+--- Thread: Crt .5 (/thread-6728.html)
Crt .5 - micro Loopie - 04-18-2007
Does the CRT.5 take regular 1/10th-1/8th size servos?
Does it use a standard RX hump?
Will it start w/ the Chrome top starter box I use for my CRT?
Any .12 engine??
Crt .5 - Tex - 04-18-2007
It takes servos smaller than normal
I think it comes with a hump pack that consists of AAA's
Not sure about starter box, probably will work
any .12 engine with a SG shaft (pilot shaft)
Crt .5 - Czech-it-Out Graphics - 04-18-2007
bradley runs a TZ in his
Crt .5 - micro Loopie - 04-18-2007
Tex Wrote:It takes servos smaller than normal
I think it comes with a hump pack that consists of AAA's
Not sure about starter box, probably will work
any .12 engine with a SG shaft (pilot shaft)
Where does one get smaller than normal servos?
Czech-it-Out Graphics Wrote:bradley runs a TZ in his
I'd probably run one as well...When I made the thread I thought a .18 wouldn't mount into somthing that fitted a .12, I was wrong
Crt .5 - Tex - 04-19-2007
I think Chad Bradley runs the .12TZ, not .18 although I could be wrong.
The .18 should fit if you really want to go that route but it would be seriously over powered. Actually I've seen a video of a .5 with a .18tz and all it did was wheelie all over the place... even with the diffs setup to race
Crt .5 - Whitey04 - 04-19-2007
I can start my inferno 09 on my bump box, 1/8th offroad box.