10-05-2006, 10:57 PM
Nope nothing and I am jonesin for it too.
I would rather have a tank than RC.
Does a lot for my High blood pressure
No on average you get about 25 to the high side 40 cents on the dollar and to get the most you sit on it and wait it out.
It took me 8 months to sell the tank, stand and canopy and I got a bit over a grand for it. IT was hand made by me and I have a rep for some kick but custom built fish furniture.
BTW
I also make stuff out of acrylic like sumps and I design them too.
Like that 150 stand and canopy on my site---that was $950 but I build them overkill.
The black one I built could hold a car on it.
FWIW
Regular water is about 7lbs per gallon
Salt water is 10-11 lbs per gallon.
So imagin 180 gallons then the tank at 330lbs and then the furiniture another 350lbs
You are already over a ton. I had to re-enforce my floor joists to support the load in two places
I would rather have a tank than RC.
Does a lot for my High blood pressure
No on average you get about 25 to the high side 40 cents on the dollar and to get the most you sit on it and wait it out.
It took me 8 months to sell the tank, stand and canopy and I got a bit over a grand for it. IT was hand made by me and I have a rep for some kick but custom built fish furniture.
BTW
I also make stuff out of acrylic like sumps and I design them too.
Like that 150 stand and canopy on my site---that was $950 but I build them overkill.
The black one I built could hold a car on it.
FWIW
Regular water is about 7lbs per gallon
Salt water is 10-11 lbs per gallon.
So imagin 180 gallons then the tank at 330lbs and then the furiniture another 350lbs
You are already over a ton. I had to re-enforce my floor joists to support the load in two places
Life is like Beavers, One Damn thing after another- Unknown
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.
If your not breakin parts your not going fast enough-Biodragen
NTC3 RTR assoc .15
NTC3 OS .18
Losi 8T, JR8611a ST servo, Futaba 9350 Th\Brk Servo, RB-C6BB Motor and Novarossi 528XR.