Inferno GT Buildup (pics)

[SixVi6-Camaro]

ohh yeah.. I got the Inferno GT today that replaces my out of date Kyosho Landmax 2. Basically Inferno GT is a 7.5 buggy converted to "Rally Game" as they call it in UK. Here it goes!

All stock.. It was like this for about 10 minutes..


the Old half buggy converted Landmax 2 that sports lots of hop ups and the All stock inferno GT.


15 minutes later the inferno GT was in pieces.


these are the only parts of the inferno GT that I used!


And the parts of the inferno GT I didn't use. lol!


OK After drilling holes and dremeling the JT chassis the 2 speed and fuel tank is mounted!


Rear assembly complete using the Inferno GT shock tower, body mount, and shocks only.


Front end is assembled again using the GT's shocks, shock towers, and bumper.


Radio tray and electronics all on!


and complete.. Lots of mods to get that engine mounted though. I had to dremel off the stock casted in motor mount, pull off the Massive diamater stock flywheel, Take off the pull start (too big and was hitting the Driveshaft) It was a pain but the motor sits a almost 1/2" lower than stock mounts.


And all the leftover parts!! these will go toward getting the truggy some new plastic and electronics before I sell it.


Pretty much this has got to be the most hoped up Inferno GT on the planet... lol! Also the pics don't show it but the the body on this thing is huge. body is almost 2' long and its a foot wide. Tomorow I break in the engine and get some good pics of it before I run it! :joy:


HAHA!! also just noticed that I didn't open any of the stock RTR radio gear, instructions, or tools that came with the thing.