08-07-2006, 09:03 PM
Yeah the EPA's were ok, it's just a small thread on the rob into a soft plastic part is all. I got them set collared tonight and finished the break-in. Got temps up to 215'ish with plenty of exhaust smoke and the motor mnoves it right out. I'm sure I'll sneak up on getting it leaner and faster, but plan to take it slow. Big blocks are gas hogs! Jeez...10minutes on a break-in tank just putting back and forth.
Anyone know for sure if the Pro28 motor needs a shim for 30% OD's fuel? Thanks.
Anyone know for sure if the Pro28 motor needs a shim for 30% OD's fuel? Thanks.