10-10-2005, 09:25 PM
yup gabe is right on! most all the .21 clutch setups will work on any big block 1/8 scale engine. the exceptions are very few.. Kyosho GS21's have a goofy special flywheel.
about the engine not being able to turn with the flywheel on. all I can think of there is you are tightening the flywheel way to tight? I dunno.. did you remember to put the Cone shaped washer on then slip the flywheel over? dunno what else it may be. I'd not try tunring over that engine much by hand until its broken in. If you have to turn the engine by hand make sure there is a lot of lube in that thing!
about the engine not being able to turn with the flywheel on. all I can think of there is you are tightening the flywheel way to tight? I dunno.. did you remember to put the Cone shaped washer on then slip the flywheel over? dunno what else it may be. I'd not try tunring over that engine much by hand until its broken in. If you have to turn the engine by hand make sure there is a lot of lube in that thing!
-- John --
1:1.. 01 Z28 Camaro A4 Sure.. its stock.
1:8's.. K3, Inferno GT, and a straight line beater car
1:18.. RC18t Mamba and 3s lipo
1:1.. 01 Z28 Camaro A4 Sure.. its stock.
1:8's.. K3, Inferno GT, and a straight line beater car
1:18.. RC18t Mamba and 3s lipo