I wanna see it run
Go to the race for the cure at LHR on april 22nd
Oh god I'm screwed at the race lmao....
Cause...I probably can't keep up w/ all the good guys....I gotta get some cash fast and get that center diff.
A center diff won't save you!!
Obsessive R/C Wrote:A center diff won't save you!!
lol!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Matt you wouldn't stand a chance against electric stadium.
:owned:
Obsessive R/C Wrote:Not really sure what the exact size is, but it is the original needle that came with the airbrush (Iwata HP-BC) For the really fine detail I remove the crown cap, but if you do this the needle tip is very vulnerable to damage, so you need to be really careful.
Does it have grooves/rings on the butt end of the needle? And, are you racing at the Cure Race?
Jerry I hope that you are coming out to the Cure race. I want to see this bad boy in person. The sad thing is you could probably walk into your garage and grab an RC from every class that would make us all jealous...
DAVEC-NITRO-RS4 Wrote:Does it have grooves/rings on the butt end of the needle? And, are you racing at the Cure Race?
I looked it up and its a 0.5mm
Iwata Eclipse HP-BCS (fourth one down in the link....
http://www.cagsol.com/airbrushes.htm
Absoloutly SICK. I need to change the name under my screen name and give it to you!
That motor is going to be rediculous in there.
The more I look at that revo, the more I want it, and I can't say that about too many revos.
I just cannot get over how flawless it is. It is perfectly thought out... everything. That is the nicest revo I have EVER seen... (I am honored to have my rocker arm posts on there. LoL)
Wow..thanks guys. Now I really feel the need to back it up and get this thing running and dialed in
I like how you blacked out everything you could, looks very stealth
wow...that thing is beautiful
Yeah, it's nice, hopefully it performs as well as it looks, I have no doubt though!
have you figured out the linkage yet Jerry? It has to be custom made because of where your throttle servo is.
Also you may want to think about metal standoffs for the servo, it flexes alot under pressure and the plastic will only make it worse.
I'm working on the linkage, I need to pick up servo horns. I will probably replace the plastic stand offs with aluminum. I also need to decide on a pipe that will work well with that engine.
You thinking side pipe like Tex used to have or regular revo onboard pipe?
Id say side pipe and a nova 9886 or mugen 1005