06-24-2006, 01:09 AM
its not standard its metric, they dont use american sizes in italy lol it just happens to be a size in between 2 and 2.5mm or sumthing like that, I happened to have the size in a set of RE allen drivers.
George right out of the gate put the thin shim in, those guys are full of chit because i had some detonation on the piston and head button, plus it should be easier to tune. for breakin take the plug they give u and throw that POS out dont even put it in the motor. I started with 4 out on both needles to break it in 3 out on top and 4.5 on the bottom is pretty much what im at now.
Next run will be tomorrow in my buggy at LH hopefully it will go well.
George right out of the gate put the thin shim in, those guys are full of chit because i had some detonation on the piston and head button, plus it should be easier to tune. for breakin take the plug they give u and throw that POS out dont even put it in the motor. I started with 4 out on both needles to break it in 3 out on top and 4.5 on the bottom is pretty much what im at now.
Next run will be tomorrow in my buggy at LH hopefully it will go well.
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT
alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT
alute:Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"