Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
(RC) Real Street Drags Sat. Oct.23rd
#50
yeah and not seen in the pic.. because I could not find it after the crash.. was a 1/4" thick AL brace with large ball ends at either end that tied the front to the center of the chassis. It was just gone after the crash. you could see where the screws had ripped clean out of its mounting points but I could never find that brace. I bet it was bent good. when it hit that curb it didn't bounce, spin, flip, or anything. just went crack.. dead stop.
-- John --
1:1.. 01 Z28 Camaro A4 Sure.. its stock.
1:8's.. K3, Inferno GT, and a straight line beater car
1:18.. RC18t Mamba and 3s lipo
Reply


Messages In This Thread
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-05-2004, 11:46 AM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-05-2004, 11:57 AM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-05-2004, 12:43 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-05-2004, 03:22 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-05-2004, 03:43 PM
(RC) Real Street Drags Sat. Oct.23rd - by TowShen - 10-05-2004, 05:04 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-05-2004, 06:08 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-10-2004, 01:27 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-10-2004, 02:10 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-10-2004, 02:10 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-10-2004, 09:02 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-10-2004, 09:29 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-11-2004, 10:26 AM
(RC) Real Street Drags Sat. Oct.23rd - by TowShen - 10-11-2004, 11:02 AM
(RC) Real Street Drags Sat. Oct.23rd - by SixVi6-Camaro - 10-11-2004, 03:58 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-11-2004, 08:34 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-15-2004, 12:39 AM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-16-2004, 09:13 PM
(RC) Real Street Drags Sat. Oct.23rd - by Tex - 10-20-2004, 02:02 PM

Forum Jump:


Users browsing this thread: 3 Guest(s)