01-03-2006, 01:59 PM
It doesn't use "Freq's" like the AM/FM radios. Well it does, but it's spread spectrum technology like telephones, and searches "listens" for open "channels" and then takes one and locks it's use to just your radio/rx. There are 79 channels that Spektrum can access. So unless all 79 are in use at the same time, you will get assigned one.
______________________________ from their website.....http://www.spektrumrc.com/DSM/Technology.aspx
HOW DSM WORKS
Collision avoidance eliminates the possibility of more than one Direct Sequencing Spread Spectrum system from transmitting on the same frequency. Here's how it works: When the transmitter is turned on, the system scans the 2.4GHz band looking for an open channel. 79 channels are available. When an open channel is found, the system locks in and transmits on that channel as seen below. (cute animation not copied here)
This process takes about 2 seconds. In the unlikely event an open channel is unavailable, the transmitter continues to scan without emitting a signal until an open channel becomes available. The transmitter will remain on that selected channel until it's turned off. Each individual module is factory programmed with its own unique serial code called GUID (Globally Unique Identification code). Once a receiver is programmed to a specific module (called binding) the receiver will only recognize that module ignoring signals from any other sources. And with over 4 billion possible GUID codes, it's virtually impossible for a receiver to listen to anything other than its bound transmitter.
When the receiver is turned on, it scans the 2.4GHz band and searches for its specific transmitter's encoded signal. When found, it locks in on that channel. If the signal is lost, the receiver goes into a hold mode, positioning the servo to a preset fail-safe position until the signal is reacquired. If the receiver is turned on before the transmitter, it will continuously scan the band until the encoded transmitter signal is present. During this period, the receiver drives the servos to the preset fail-safe position. All Direct Sequencing Spread Spectrum systems are required by the FCC to incorporate active collision avoidance, making it impossible and illegal for more than one transmission on a single frequency.
______________________________ from their website.....http://www.spektrumrc.com/DSM/Technology.aspx
HOW DSM WORKS
Collision avoidance eliminates the possibility of more than one Direct Sequencing Spread Spectrum system from transmitting on the same frequency. Here's how it works: When the transmitter is turned on, the system scans the 2.4GHz band looking for an open channel. 79 channels are available. When an open channel is found, the system locks in and transmits on that channel as seen below. (cute animation not copied here)
This process takes about 2 seconds. In the unlikely event an open channel is unavailable, the transmitter continues to scan without emitting a signal until an open channel becomes available. The transmitter will remain on that selected channel until it's turned off. Each individual module is factory programmed with its own unique serial code called GUID (Globally Unique Identification code). Once a receiver is programmed to a specific module (called binding) the receiver will only recognize that module ignoring signals from any other sources. And with over 4 billion possible GUID codes, it's virtually impossible for a receiver to listen to anything other than its bound transmitter.
When the receiver is turned on, it scans the 2.4GHz band and searches for its specific transmitter's encoded signal. When found, it locks in on that channel. If the signal is lost, the receiver goes into a hold mode, positioning the servo to a preset fail-safe position until the signal is reacquired. If the receiver is turned on before the transmitter, it will continuously scan the band until the encoded transmitter signal is present. During this period, the receiver drives the servos to the preset fail-safe position. All Direct Sequencing Spread Spectrum systems are required by the FCC to incorporate active collision avoidance, making it impossible and illegal for more than one transmission on a single frequency.