transmission shot or clutch?

[mikeh]

I did not think of the reverse module. Thats a possibility. My problem with the slipper occured because it loosened, then melted the center of the spur. This caused the spring to push the bushing into the soft plastic and then the slipper could not tighten it enough because the bushing was in too deep. I pulled my hair out trying to figure it out. Thats why I had to replace the spur gear, spring, and rough up the slipper disk. I had no problems since.

but the reverse module is a new one to me. The linkage is a bit tricky to get just right, but then it was not prone to problems.

By the way, if it has not been said, welcome to the board!