03-07-2005, 12:22 PM
Is the RX pack charged (freshly)
Yes
What servo are you using on Th/Br?
I am using the original steering servo as the throttle/brake servo.
The screw that hold the pads are coming loosing on you?
Yes, the screws that go through the pads and hold them in place.
the brake hold down screws?those screw into the lower trans, there is no metal there,all plastic ,sounds like you striped out the screw mounts so the screws come out when pressure is added.
I know there is no metal in there, I have never over tightened them and if I take the trans out and put a screw in the hole, it stay in, even when I try to pull them out. If the holes were stripped the screws would slide right out when I put pressure on them.
how long of a screw are you using?
I am using the stock screw that was on the original brake kit. I am however running a modified version of the original brake setup.
Maybe Im just to hard on the brakes?
Yes
What servo are you using on Th/Br?
I am using the original steering servo as the throttle/brake servo.
The screw that hold the pads are coming loosing on you?
Yes, the screws that go through the pads and hold them in place.
the brake hold down screws?those screw into the lower trans, there is no metal there,all plastic ,sounds like you striped out the screw mounts so the screws come out when pressure is added.
I know there is no metal in there, I have never over tightened them and if I take the trans out and put a screw in the hole, it stay in, even when I try to pull them out. If the holes were stripped the screws would slide right out when I put pressure on them.
how long of a screw are you using?
I am using the stock screw that was on the original brake kit. I am however running a modified version of the original brake setup.
Maybe Im just to hard on the brakes?