06-12-2007, 12:01 PM
make sure when you put the allen key in the hole you aret urning the right screw thre are 2 screws in there, 1 turns the shift point and the other holds the clutch set up to the shaft
how do you tell which one your turning? easy
the hole is top dead center of the gear and if you try turning th scrww that aligns straight in then you got the wrong one, the shift poing screw is on an angle so the allen key actually goes a little to the side of the gear but still in the geart, its kinda hard to describe it, but i think yuou will be able to tell what im talking about after looking at it
how do you tell which one your turning? easy
the hole is top dead center of the gear and if you try turning th scrww that aligns straight in then you got the wrong one, the shift poing screw is on an angle so the allen key actually goes a little to the side of the gear but still in the geart, its kinda hard to describe it, but i think yuou will be able to tell what im talking about after looking at it
member of the smackahoe tribe 
lap:
Violator 9.5 Jammin CRT Kyosho Inferno GT HPI MT
lap: Violator 9.5 Jammin CRT Kyosho Inferno GT HPI MT