04-04-2007, 02:14 PM
yes u can, the clutch doesnt have much to do with it, the screws go in alot faster with the drill and with the tight fit b/w the machine screws and the plastic it generates alot of heat (ud be surprised how hot the threads get) and this softens the plastic. If u do a lot of wrenching ur stuff will strip alot sooner
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT
alute:
Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT
alute:Bringing old know-it-all blow hards back to reallity at a forum near you
"Always Imitated, Never Duplicated"