Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
new vspec question
#1
ok here is my question i have a os vspec im running 30% the guy at the odonell both at the ihobby show said i can run only one shim in the motor i have 2 shims right now a copper shim and a silver shim if i remove one shim what diffrence will it make in the motor? will i see any more top end? lower end... what i have no clue have you ever heard of this please give me some info if you have any on this issue
Reply
#2
more low end, higher temps, harder to tune, worse fuel mileage, leave the shim in ull be fine lol
Here is a link to my website-
http://www.czech-it-out-graphics.com
1/29/07 never forget....TTT Confusedalute:
Bringing old know-it-all blow hards back to reallity at a forum near you

"Always Imitated, Never Duplicated"
Reply
#3
same as i said huh? Wink

GS RACING, TQ FUEL, FASTLANE GRAPHIX, CZECH-IT-OUT
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  maxx .26 question towman 1 3,212 01-02-2011, 03:15 AM
Last Post: Racin' Ranger1
  question about a vspec engine eraser 83 16,424 02-06-2008, 04:36 PM
Last Post: J-Dub
  question about a new motor eraser 20 5,418 10-14-2007, 12:39 AM
Last Post: willitbme15
  os vspec carb eraser 17 3,949 10-06-2007, 02:30 PM
Last Post: eraser
  what pipe to run with a os vspec eraser 32 8,619 10-05-2007, 06:52 PM
Last Post: allan42r
  question about rc stuff rayk504 1 1,874 09-04-2007, 03:53 PM
Last Post: Mr. Tune
  8ight Clutchbell Question motoxer4life 19 5,371 07-16-2007, 09:53 PM
Last Post: cr4sh_27
  clutch bell question eraser 2 2,189 04-21-2007, 12:30 PM
Last Post: rocco79
  clutch nut question mikev 11 3,731 04-19-2007, 07:43 AM
Last Post: MX_KEVIN
  OS 18 tm question Meatwad 4 1,895 02-27-2007, 06:59 PM
Last Post: Mr. Tune

Forum Jump:


Users browsing this thread: 1 Guest(s)