+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Tech Forums (https://www.chitownrc.com/forum-7.html)
+--- Forum: Electronics / Radio (https://www.chitownrc.com/forum-19.html)
+--- Thread: Airtronics / servo horns (/thread-6026.html)
Airtronics / servo horns - Obsessive R/C - 02-18-2007
I have an Airtronics 358 & 359 & the aluminum servo horns seem to fit slightly loose compared to a JR....these are supposed to have the same spline according to the p/n of the horn...
I've always used JR or Hitech servos, this is is my first time using Airtronics, is there something I missed??
Thanks ORC
Airtronics / servo horns - Ponch - 02-18-2007
Whoops. Wrong info, sorry.
Airtronics / servo horns - rocco79 - 02-18-2007
Ponch you are a moron...
They are the same Jerry...
Airtronics / servo horns - cemeb4dk - 02-18-2007
They are the same as Roc stated. I had some aluminum ones that fit loose also, I believe they where racers edge ones, they never fit right and scraped them. It seemed to me that the teeth where not long enough to grab and the time I tried it, it just spun and strippe dit out on the bench test.
Airtronics / servo horns - Obsessive R/C - 02-18-2007
They fit nice and snug on the JR servo...but when I put them on the Airtonics they just seemed a little sloppy. Once you tighten them down they seem fine but I'm not sure I trust them.
Airtronics / servo horns - dentguy92 - 02-18-2007
just run them.... It will be fine...
Airtronics / servo horns - Tex - 02-19-2007
on the air servos the metal horns are loose, same way on my old 359. Works fine it's just loose (which I didn't like)
Airtronics / servo horns - chris arnold - 02-19-2007
remember on metal horns to make sure that they are not too long and rubbing on the case. i know i had a dynomite horn on a air servo do this once and i chased it around all day filed the back of teh horn down and life was good
Airtronics / servo horns - Obsessive R/C - 02-19-2007
Good call....I'll have to check that, thanks
Airtronics / servo horns - Tex - 02-20-2007
yep, forgot about that. I also filed down my metal horns on when using air servos