Need help! - Printable Version +- ChitownRC (https://www.chitownrc.com) +-- Forum: Main Forums (https://www.chitownrc.com/forum-4.html) +--- Forum: Racers Forum (https://www.chitownrc.com/forum-9.html) +--- Thread: Need help! (/thread-3482.html) |
Need help! - MasterWolf - 05-03-2006 Hey all, I got a revo and was wandering how you check toe-in useing rpm toe-in gauge Need help! - maxximum_44 - 05-03-2006 You can use a camber gauge to measure toe angle. Position the centerline of the chassis perpendicular with the edge of the table, and place the bottom of the camber gauge flat against the edge of the table. Set the camber gauge to the desired angle setting, then adjust the toe link until the wheel angle meets that setting. Need help! - DAVEC-NITRO-RS4 - 05-03-2006 That picture must be doing a rear wheel, becuase it says "Never use" for toe-out. True, for rears, unless rock crawling, not true for front wheels. Need help! - maxximum_44 - 05-03-2006 LOL, didn't even read that crap! He asked how to check it with his gauge,so I gave him a visual refrence to go with the info Need help! - MasterWolf - 05-03-2006 ahh cool thanks guys but any idea witht he toe-in gauge ? Need help! - maxximum_44 - 05-03-2006 Oh, toe-in gauge LOL!!. I've had a RPM toe-in gauge for years but, never used it.sorry bout that Need help! - Racin' Ranger1 - 05-03-2006 ya it is the rear its a maxx(notice the pipe) |