+- ChitownRC (https://www.chitownrc.com)
+-- Forum: Tech Forums (https://www.chitownrc.com/forum-7.html)
+--- Forum: Engine / Drivetrain (https://www.chitownrc.com/forum-17.html)
+--- Thread: Rex P5 problems (/thread-3475.html)
Rex P5 problems - maxximum_44 - 05-02-2006
When I tighten the flywheel down, it does not spin freely, it feels as if the flywheel is contacting or rubbing the crank case. When I loosen it ,it feels okay. My vspec uses the same flywheel combo and does not suffer from this, I can move the piston easily up and down with my finger(not past the pinch)on the vspec but not on the P5. I tryed both the cone that came with engine and the one that came with the kit, both are doing the same. Did I over tighten? aren't I supposed to tighten it down? what do I do?
Rex P5 problems - snakebite46 - 05-02-2006
Try using a shim behind the collet.
Rex P5 problems - maxximum_44 - 05-02-2006
Alright I'll try that, Thanks.
Rex P5 problems - maxximum_44 - 05-02-2006
Any easy way to remove the collet?
Rex P5 problems - squirrel - 05-02-2006
Flat head screwdriver? Try to get behind it and wegde it off.