can someone paint my plastic valve covers for my mustang??
You know you will have to use a high temp paint right (one that can stand the heat)?
something like for a weber grill
They make motor paint mike, its prolly the best choice
im sure it is, it was a joke
Urethane automotive paint would be your best choice.
so im looking for some kind of silver/grey/or green flame job. the car will be in a few mags in 08, and i just want something cool looking. or, i am also up for ideas....
I don't think Im gonna be able to make time to do it. If jerry or dave aren't up for it I bet I could find someone on the grid or CFX that would do the job
Green Hornet Wrote:so im looking for some kind of silver/grey/or green flame job. the car will be in a few mags in 08, and i just want something cool looking. or, i am also up for ideas....
So are these for a show car that won't get hot? Because then it's any paint that sticks to steel or aluminum. I'd think HOK would be sweet, but $$$ and smelly!
I do have a couple of automotive sprayers that haven't been used in a while, and a touch up gun.
the car is 95% drag car only, and will get driven to a few shows. the valve covers are made of plastic.
hmmm. plastic and higher temps....epoxy or polyurethanes do sound like the only choices...how about wraps? Fastlane Graphics!
I would recomend TK customs (although it might run you up a few $$$), if you can't find somone local.
DAVEC-NITRO-RS4 Wrote:hmmm. plastic and higher temps....epoxy or polyurethanes do sound like the only choices...how about wraps? Fastlane Graphics!
id be open to ideas for that also.