ChitownRC

why arent u on yahoo

what about over draft fees. they rape u with those

wtf are u talkin about

inferno st Wrote:what about over draft fees. they rape u with those

Just messing up my thread....

nice lsp. better

I'm going to try and get pics up later tonight. New wing on, all of the electronics are in, motor is set in, just waiting on the clutch setup (should be here early this week) and then I will pick up some plugs, 2 stick packs, and it's on!

Just waiting for the Clutch setup and some glow plugs.

looks good man!

Looking good Dan

that thing looks like a brand new RC

Nice lookin truck there Dan can't wait to see it in action next week? Right!

Thanks guys! It will be racing next week. I hope I didn't lose all of the skills I managed to get back over winter break, especially since I won't get to practice the week before. Oh well, I'll see what it can do.

M2C Clutch installed, servos set up, stick packs charging for the starter box..... should be ready to break in the motor tomorrow and race on Sunday.

awesome Dan.... GL this weekend dude

Frost-
Dont over lean it while breaking in... John and i did that because during breakin it was pig rich then durning his 1st heat it was extremley lean. The werks needles turn very easily too...

rocco79 Wrote:Frost-
Dont over lean it while breaking in... John and i did that because during breakin it was pig rich then durning his 1st heat it was extremley lean. The werks needles turn very easily too...

Yeah.... I am trying to be real careful. It is cold out so not ideal break-in conditions, but I hit it with the heat gun before starting and have a papertowel around the head to keep temps at about 230 right now. It was actually lean on the low end out of the box so I richened the low end. I haven't done any fast runs with it yet, but even at about 1/4-1/2 throttle at most there is a GOOD amount of smoke. I may or may not get to finish it tonight. Hopefully I can get it done at the track in the morning if things don't change here. (Damn Hitec)