Well all my goodies came from Slow Revo today (Thanks!!). I am going to glue up the wheels and tires. They are for indoor, and the wheel is vented already from the factory. Do I need to vent the tire or no? I am pretty sure that venting the tires is for outdoor only, but I am not 100% sure.
Thanks
Dan
unless u do big ones then two but id stick with more of a smaller whole^
ORL?? Hmmm... Allright then. About how big on the 4 holes?? Like the size of a headphone jack?
Czech-it-Out Graphics Wrote:like the size of a M3.5 screw
Beceause I know EXACTLY what that is without a scre kit here. Haha.... I'm retarded remember?? Compare it to something I probably have siting on my desk right now. Haha
how bout a 2.5 hex driver?
Funny that that would be the exact same size as a headphone plug. Hahaha....
I don't think tires need to be vented for indoor use. It's not like it's dusty inside, lol.
Mr. Tune Wrote:I don't think tires need to be vented for indoor use. It's not like it's dusty inside, lol.
See that is what I thought.:confused:
u wash ur tires dont u dimo? waters gotta get out some how and the only way out is through the rubber dan the head phone jack from my I pod is smaller than that lol
Czech-it-Out Graphics Wrote:u wash ur tires dont u dimo? waters gotta get out some how and the only way out is through the rubber dan the head phone jack from my I pod is smaller than that lol
I know that I don't wash my tires. Now you say they won't swell as much when vented. Why? The rim is vented and I don't see wht it would make a difference in them swelling under acceleration. If anything I could see it being worse. Aren't I more likely to tear a tire when they are vented as well??
Indoor-No tire vents
Outdoor-Tire vents
Ponch Wrote:Indoor-No tire vents
Outdoor-Tire vents
No vent: 1.5 votes (Ponch only counts for 1/2)
Vent: 1 vote
Mike...sponsored racer +1
Ponch....??
I'd say vent. It can't hurt...
dan u will never rip a tire. When you accelerate anything inside the tire is automatically pushed against the rubber itself because of its inertia. with a vented rim and no vented tire it is much easier for more air "to be sucked in" along with any other junk out there. Once the air is in and you spool up the tires where does the air go? it gets trapped inside the tire for that moment.
Mike that makes sense. Thanks for explaining it.
Wow..... Cramming these foams in here is round peg square hole al over again.
Stock white ones. Have heard nothing but good things about them. I prepped a tire so I figured why not cram it in there.
when u get the foam about most of the way, put a thumb ur two of ur fingers on the at the top and bottom of the bead u would glue down and move ur hands in like a rolling motion and the foams will fall right into place then just slide it onto the tire
Vent the rubber and put a sticker to cover the hole on the rim if there is one already there. Mikey is right on the money. If you get alot of mud on the tire from the track getting muddy in spots like between the tubes, the tires get loaded with mud and you have to clean them off. If you listen to Dimo, i have seen him not vent anything and he was riding on balloon tires.
ive seen dimo take an exhaust deflector out of the garbage and put it on his revo too
lmao
Gotcha. I have all of the tires prepped so I will put holes in them.
wait omg did JT just say I was right???? holy phuck i think hell just froze over hahaha
I seen ponch take a half eatin riblet sandwich out of the garbage can and eat it too.
