well yesterday and today i had the greatest bash in my life. i went to jakes house and he has a revo2.5 and we were catching some great air. and bashed till 3 in the afternoon till 3:30 at night. he lives on a farm so no annoying neighbors. well after frying his tranny at about 1:30am we switched to my truck. we jumped it a good 25feet up and landed on flat ground. any ways anyways on to the trouble. we went out at 2:30 with my truck to have another jumping sesion when my motor wouldnt start. put 3 plugs in heated with a hair dryer and finally after 45mins it fired. well i was jumping and everything seemed to be smooth then he's like...i dare u to make the ramp steeper and hit it wot. so i did. i got the most air this truck has ever seen. it was nuts. then i landed and when i tried to go wot the engine will hit top rpms get ready to shift and backfire like ten times then idle. its almost like a car when you run a to low octane gas and the piston's ping from the gas igniting before the piston comes back up. i dont no if it was cold or what the hell is wrong with it. some help would be appreciated. thank you
Eww, that's an odd sound. Just to be sure, pull apart the motor and look for anything out of the ordinary.
one of the cooling head screws it stripped
Ok well take apart what you can then. Take off the backplate, look inside. Also, feel the diffs, check the slipper clutch setup.
I got an idea, dont break my revo.
2.5 are notoriois for snapping rods
Czech-it-Out Graphics Wrote:rod
^
inferno st Wrote:2.5 are notoriois for snapping rods
Never seen that happen..but ok..It wouldn't run if the rod was snapped dude.
The rod might have excessive play, that might cause what is happening.
i didnt say it snapped i just said thats where the problem is
i snapped three 2.5 rods i should know
Czech-it-Out Graphics Wrote:i didnt say it snapped i just said thats where the problem is
Sorry I was talking to inferno st in that first line Mike.
inferno st Wrote:i snapped three 2.5 rods i should know
If you snapped three rods you got some problems...Something else is probably f'd too if it's the same motor.
lol blow and rod and just put a new one in the same motor, everything else should be fine right?????? hahahah
i put i different glow plug in and it was fine. i think it was to hot