ChitownRC

I received my OFNA starter box today. I was wondering how exactly are you supposed to position the pegs? Like are they suposed to be in one of the holes on the front arms and rear or what? I am using the box with a buggy.

Yes, you basically position them in a way so that the flywheel lines up over the rubber wheel.

I set mine up so that in the front the pegs went between the arms and the chassis, and the same on the rear. They were sorta cone shaped, so if you dropped the buggy on there it'd line right up.

If they are the pegs with the flat sides on top make them line up with the chassis so they look like this

front........./ \

rear..........\ /

The fronts are just straight up and down and the rear are tiny cone pegs. I will get pictures tomorrow of how I have it now, and see if anyone has any other suggestions.

If it lines up then it's good! As long as the wheel doesn't rub on the chassis your set!!!

it can be set up so many different ways, I'm sure you have it in a way that would work.

I put the pegs in a different spot than I originally had them because the buggy was able to move forward a little bit which would allow the wheel to hit the chassis.

The only problem I see with this set up is when I am taking the car off the box, the chassis will rub the posts and take a lot of plastic off. It took some off just taking the car off a couple times.

If the rubbing is really bothering you, pick up another set of the cone posts. (Hope that really didn't sound too bad)