Ok, I would have sworn when I looked in the hole in the trans I could see peices of plasitic, but I guess I didn't blow any gears. (mods can delete the WTB thread) O.K. So heres what it is doing, all of the gears are good, i spin the spur gear and none of the gears inside will spin, I know absolutley nothing about transmissions so any help at all is apreciated, I'll probally take it into LH tomorrow if know one knows what to do.
will it not spin when you drive it or when you spin it by hand?
i took it out and when i spin it by hand it wont spin, i didnt take all the gears out to see if i broke the shaft or something
Sounds normal to me if you have a stock trans with reverse. The trans has an internal clutch that will engage when rpm's are generated.
i dont have reverse, and it wont go, i think i must have broke a set screw or something...
either take it apart yourself or take it to LHR or hobbytown
i did take it apart, im pretty sure it is a set screw behind the spur gear right inside the trans case. Im not sure what I'm doing in there so I'm going to take it to LH tomorrow and see what they say.