ChitownRC

Yes/no?

I would think so.... Im not sure if the shaft off the would matter or not

does the t-15 have a short shaft?

T-15?

If you mean the mill that can with the original Tmaxx, then no it wont fit with out mods. The backplate and the flywheel on that engine is too big, it wont fit on any of the motor mounts avail. for the GT.

Except prob. the .21 motor mount for the GT from GPM!! I've thought about that one for a while...but drivetrain wouldn't last long at all.

again ......t-15???? is that the TTR or HPI motor?

Hpi

Ohhhh!!

is it a short crank or a long crank?

Shorter than the Associated .15

you could try a different flywheel nut with an extension on it.

Go here RC10GT FORUMS These guys would probably know for sure. It's where I go if I need a GT question answered.

pop hows your gt running?

Its doing well, I need to put some new tires on it (once I get some cash). I took it out to the DeVry spot about two weeks ago and lost a servo mounting bracket screw, replaced that. Then I took it to a park by my grandfathers house with my son and ran it for about an hour. We had like 10 kids chasing it around in circles. It was pretty funny trying to not crash into them. We are gonna take it back to the DeVry spot tomorrow or Sunday or both, wife permitting. To start really tuning it for power (I pick up a Duratrax Temp sensor ) and then see what she really can do! I was thinking I might take it out to Intense Raceway Sunday, but Im not sure I'll have time, plus I am alittle under the weather.

Good to hear. we finally got my buds "Gt" going. turned out to be needle settings on the picco
just as I had suspected. Not very funny when a Manufacture gives you general needle settings for an expensive mill that are way out of the ballpark, Im glad we didn't ruin it.

Be sure to post if your going to Devry this weekend, I might join ya if I can get out.

All right I'll do that, wouldnt mind somebody else to bash with. I'll post tomorrow morning first thing whether is a yay or a nay.