09-27-2006, 10:15 AM
Since not everyone has SGrid access, I thought I would copy/paste this info about Richard Saxton's ST-1 setup for indoor tracks. Get out your checkbooks!!!
______________
Saxton indoor ST-1 setup:
I ran the BCE chassis, that makes a big difference,
I also use the S3 rear shock bodies on all four coners, but use the ST-1 front shaft, pistons drilled 1/16th.
Front oil 35 rear oil 60, caster all the way forward.
Front tower top hole outside, front arm outside,
rear tower middle bottom, inside on the arm.
Front spring ST-1 black also use that spring in the rear.
Diff 5000, 10,000, 3,000.
Gold sway bar in the rear, silver in the front.
Camber link inside and up on the tower, hub outside and up.
Caster forward. Hubs in the middle
Make sure on the front shocks no shock boots
______________
Saxton indoor ST-1 setup:
I ran the BCE chassis, that makes a big difference,
I also use the S3 rear shock bodies on all four coners, but use the ST-1 front shaft, pistons drilled 1/16th.
Front oil 35 rear oil 60, caster all the way forward.
Front tower top hole outside, front arm outside,
rear tower middle bottom, inside on the arm.
Front spring ST-1 black also use that spring in the rear.
Diff 5000, 10,000, 3,000.
Gold sway bar in the rear, silver in the front.
Camber link inside and up on the tower, hub outside and up.
Caster forward. Hubs in the middle
Make sure on the front shocks no shock boots