Crt .5

[micro Loopie]

Does the CRT.5 take regular 1/10th-1/8th size servos?
Does it use a standard RX hump?
Will it start w/ the Chrome top starter box I use for my CRT?
Any .12 engine??

[Tex]

It takes servos smaller than normal
I think it comes with a hump pack that consists of AAA's
Not sure about starter box, probably will work
any .12 engine with a SG shaft (pilot shaft)

[Czech-it-Out Graphics]

bradley runs a TZ in his

[micro Loopie]

Originally Posted by Tex

It takes servos smaller than normal
I think it comes with a hump pack that consists of AAA's
Not sure about starter box, probably will work
any .12 engine with a SG shaft (pilot shaft)

Where does one get smaller than normal servos?

Originally Posted by Czech-it-Out Graphics

bradley runs a TZ in his

I'd probably run one as well...When I made the thread I thought a .18 wouldn't mount into somthing that fitted a .12, I was wrong

[Tex]

I think Chad Bradley runs the .12TZ, not .18 although I could be wrong.

The .18 should fit if you really want to go that route but it would be seriously over powered. Actually I've seen a video of a .5 with a .18tz and all it did was wheelie all over the place... even with the diffs setup to race

[Whitey04]

I can start my inferno 09 on my bump box, 1/8th offroad box.