Exhaust Mounts - Chitown R/C - Chicago's Largest RC Car and Truck Community

DO-U-MAXX · (#1 (**permalink**))

are they different from manuf. to manuf. or are they consistant? Can you take a pipe/header combo off a buggy and attach it to a different manuf. motor and setup? I want the JP-1 pipe from OFNA and I will put in on my WASP .21SB, will it work.

Tex · (#2 (**permalink**))

make it work... that's the fun of it

DO-U-MAXX · (#3 (**permalink**))

yeah but the pipe comes with a header on it, if it does not physically fit then I will need a different header or I guess I could just use the stock header, but I would like to use the whole set.

snakebite46 · (#4 (**permalink**))

I've used and OFNA pipe/header on a OPS .21, Hyper .21 and an RB S-7 without any problems.
I'm currently running an RB motor with OFNA pipe header on my buggy.
And Werks .26 w/ RB pipe header on my maxx.
I didnt have to modify anything to get them to match up.

Hope this helps.

Tex · (#5 (**permalink**))

with the maxx drop in Wasp motor you may have problems with the .21 pipes mounting up... it is set up to except the stock 2.5 header

snakebite46 · (#6 (**permalink**))

Yup Tex is right, I thought you had a BB chassis. All the drop-in maxx motors I've seen are designed to use the stock header, except for the Fantom .18 drop-in. That motor uses a spring set-up.

DO-U-MAXX · (#7 (**permalink**))

so its the stock header with aftermarket pipe only for this application. Thanks.