Need help! - Chitown R/C - Chicago's Largest RC Car and Truck Community

MasterWolf · (#1 (**permalink**))

Hey all, I got a revo and was wandering how you check toe-in useing rpm toe-in gauge

maxximum_44 · (#2 (**permalink**))

You can use a camber gauge to measure toe angle. Position the centerline of the chassis perpendicular with the edge of the table, and place the bottom of the camber gauge flat against the edge of the table. Set the camber gauge to the desired angle setting, then adjust the toe link until the wheel angle meets that setting.

DAVEC-NITRO-RS4 · (#3 (**permalink**))

That picture must be doing a rear wheel, becuase it says "Never use" for toe-out. True, for rears, unless rock crawling, not true for front wheels.

maxximum_44 · (#4 (**permalink**))

LOL, didn't even read that crap! He asked how to check it with his gauge,so I gave him a visual refrence to go with the info

MasterWolf · (#5 (**permalink**))

ahh cool thanks guys but any idea witht he toe-in gauge ?

maxximum_44 · (#6 (**permalink**))

Oh, toe-in gauge LOL!!. I've had a RPM toe-in gauge for years but, never used it.sorry bout that

Racin' Ranger1 · (#7 (**permalink**))

ya it is the rear its a maxx(notice the pipe)