Picco P3 .26 help

[Obsessive R/C]

Anyone know the needle settings for a Picco P3 .26??

This thing will not start. Changed out the OWB added a P/S
I've changed the plug...eveything checks out. Messed with the needles...
It will not even sputter...seems tight w/ decent compression...
Everything seems fine, just can't get it to start.

[Michowski]

is your glow ignitor charged?

[Ponch]

Gas?

[Sh1nn3r]

Take the glow plug out and put it to your ignitor see if it glows.
Then see if its fluding, take glow plug out and give it a few good tugs.
Check if your fuel lines are cloged. Prime the engine and watch if fuel is going to the engine.

[Czech-it-Out Graphics]

u cant go wrong with leaning it out ONLY to get it started, once it starts keep a very close eye on the smoke and temps. My Xp was like 7turns out from flush on the low end and flush on top

[Obsessive R/C]

Glow plug lights up instantly, all lines are fresh and primed, it's not flooded and igniter is fully charged....still nothing.

Any other suggestions?

[Michowski]

do you see the fuel going through the lines and into the carb?

[Obsessive R/C]

Yup.

[Michowski]

make sure your needles arent closed

[Obsessive R/C]

I think it may be something in the carb.