mip shiney nipple?

[rusty savage]

any know the nipple size for the exhaust hose on the mentioned exhaust?
I have already cut together a header to fit a side exhaust but I need the nip!

[thenewguy821]

I believe that on the MIP pipes, the pressure line just fits in the hole in the exhaust. I had a MIP exhaust on the MAX, which was that way.

[SixVi6-Camaro]

Originally Posted by rusty savage

mip shiney nipple?

haha.. I.. OK.. I'm done.



yeah the pressure line on those MIP exhausts just goes into the hole and sits there. I really wish they would just spend the extra couple cents and put a brass 90* or straight barbed hose in those pipes. Just better piece of mind knowing the pressure line won't get pulled out as easily.

[thenewguy821]

Only put about 1/2" of the pressure line in. Gabe was having problems with the TC3 with the same type of exhaust setup, till he realized there was too much pressure line in the exhaust.

[rusty savage]

cool thanks!

[PoPRC]

My pipe on my RC10GT just has a hole in it. I dont know made the pipe but I have wondered if I could just find a small brass threaded nipple to screw in there.

[Racin' Ranger1]

same here my rc10gt has the same pipe.

[SixVi6-Camaro]

You can put a brass fitting in there but the problem I found was that the existing hole was too big for the fittings to thread into.

[thenewguy821]

Yeah, I tried to find one the right size, but with no luck. The one's with the right size nipple had too small of a threaded part, the one's with a big enough threaded part had too big of nipple and the threaded part was too long...