|
|
|
||||
|
||||
|
got a tiny problem -
11-20-2005, 01:26 AM
hey im installing some new rear hubs on my mayhem buggy so i can run it tmo, and like im trying to get the hex off so i can take out the axle and bearings and put it in the new hub but i can figure out how to get it off...like i undid the screw in the center of the hub and i was pretty sure that was it but nadda. then i just am stuck nand have no clue how to do this... so if you could help me asap so i can have it running to run it tmo morning for a little while that would be AWESOME!!!
Thanks John 
|
|
|
||||
|
||||
|
11-20-2005, 01:35 AM
tap the pin out after u take out the set screw...in the middle of the hub there is a pin holding the hub to the axle
www.czech-it-out-graphics.com 1/29/07 never forget....TTT  Bringing old know-it-all blow hards back to reallity at a forum near you "Always Imitated, Never Duplicated"
|
|
|
||||
|
||||
|
11-20-2005, 01:51 AM
or a screw driver or whatever just hit the pin and nothin around it, should come right out
www.czech-it-out-graphics.com 1/29/07 never forget....TTT Bringing old know-it-all blow hards back to reallity at a forum near you "Always Imitated, Never Duplicated"
|
|
|
||||
|
||||
|
11-20-2005, 01:54 AM
thanks much...i felt like that was it, and i got it fixed in a jiffy. i cant wait to test it out tmo morning.....i got a nice open field and a skatepark that it will be too coldfor skaters to be at... so i got that to myself.
John
|
 |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| There's a problem here! | satoch | Off-Topic | 25 | 11-09-2005 07:48 AM |
| Dang it, first problem appears with the revo. | Mr. Tune | Racers Forum | 22 | 06-04-2005 03:20 PM |
| Diff Problem on my XXXT | Notochord | Racers Forum | 2 | 05-25-2005 10:09 PM |
| problem | NitroNoob | Racers Forum | 7 | 10-12-2004 09:07 AM |
