|
|
|
||||
|
||||
OS 21 RG Factory Settings and Carb sticking help!!! -
10-30-2005, 09:58 PM
As the title says, I need to know the factory settings for an OS 21 RG....And the carb is VERY hard to move....I took the slide out and oiled it, but no help. Tried slightly sanding it with #0000 steel wool, and that helped slightly....But also, if I take out the screw that holds the slide in, and rotate the carb so that area isn't in the right place, the carb slides out and in fine...So is there mabye some buildup of something in that area possibly? I'm really lost right now....And want to get this K2 running NOW
 Only other problem is that I can't because my glow igniter is with destroy_my_revo15....John, if you read this, give it back!!!! Oh yeah, hoping my JR650 will be enough for steering with 150oz torque....Less worked in the savage, so pretty sure this'll be fine and I've only had good experience with JR stuff... 
|
|
|
||||
|
||||
|
10-30-2005, 09:58 PM
OOps, mods if you could please move this to offroad, wasn't paying attention when I made this....
|
|
|
|||
|
|||
|
10-31-2005, 01:49 PM
moved
 The JR650z will work fine as a steering servo in the K2. Make sure your idle screw is not causing the slide to bind in your RG. (i.e. you may need to loosen the idle screw some) RBS5 RB2045 All Futaba
|
|
|
||||
|
||||
|
10-31-2005, 04:59 PM
Ok, I'll check it out.
|
|
|
||||
|
||||
|
10-31-2005, 08:10 PM
took out the idle screw completely, didn't help. I cleaned everything down, and then threw the slide in the drill and took some fine sandpaper and steel wool to it and now it fits perfectly. Hopefully I didn't take too much off, but I don't think I did. It slides so much better now! I bet the engine had some fuel leftover in it and that's what gunked it up....But at least it works now and I'll make a forum with some pics in a minute.
|
 |
| Thread Tools | |
|
|
