The General Paint Thread - Page 14 - Chitown R/C - Chicago's Largest RC Car and Truck Community

UE-Maxx · (#326 (**permalink**))

I can tell I am getting a little bit better. I have a problem with my mask lifting up some of the pinstriping. You can really see it in the 2nd picture towards to the tip of the chrome.

DAVEC-NITRO-RS4 · (#327 (**permalink**))

And another starving painter goes hungry as yet another RC owner steps into painting his own bodies.......

looks good Steve...shadows are hard, yes?

UE-Maxx · (#328 (**permalink**))

To me yes, because I couldn't get a fine line/mist. I don't know if it is my brush or faskolor is too thick. I am thinking about picking up new brush though.

DAVEC-NITRO-RS4 · (#329 (**permalink**))

What AB you using?

UE-Maxx · (#330 (**permalink**))

Paasche vl

Czech-it-Out Graphics · (#331 (**permalink**))

iwata

i usually pull the pins first, I have tried both ways and it just seems like doing the pins first just makes life easier

UE-Maxx · (#332 (**permalink**))

I think I am going Iwata. I remember you suggesting the Revolution, but when I went on coastairbrush there are a few Revolutions. Which one was it?

What do you mean you pull the pins first? You paint them first?

Czech-it-Out Graphics · (#333 (**permalink**))

ya i pull the mask and paint those in first

The Iwata Revolution HP CR or if u wanna spend a little extra green the Eclipse CS both awesome

UE-Maxx · (#334 (**permalink**))

Thanks

I always did paint them first, but it was when I pulled the mask from the area behind them that it lifted up the paint from the pinstriping.

Czech-it-Out Graphics · (#335 (**permalink**))

ur putting the paint on too thick. dry it then put the body in the freezer for about 10 minutes, or outside if its cold enough lol and it will be much easier to peal. If your gonna do chrome u really cant stop that from happening gotta spray chrome as late as u can

UE-Maxx · (#336 (**permalink**))

Ok thanks.

DAVEC-NITRO-RS4 · (#337 (**permalink**))

Steve, just a note on the Eclipse...with the stock .35mm tip, you really have to thin the paints to get good flow. The bigger .50mm tip on the RevoCR means greater flow rate. Just something to consider.

Now with thin paints like lacquers, the finer tip can shoot finer details...so it's a question of what yuo will do more of...Faskolors or lacquers.....and how much money you got!

Czech-it-Out Graphics · (#338 (**permalink**))

u really gotta thin more with the eclipse dave?

UE-Maxx · (#339 (**permalink**))

I think I am going to go with the CR because I do use more faskolor. I can just keep the small tip on my paasche for the lacquer paints.

Evil3 · (#340 (**permalink**))

Quote:

Originally Posted by Czech-it-Out Graphics

u really gotta thin more with the eclipse dave?

Yes you do. My brush has a .3mm tip, and I normally thin my paints down to a 50/50 mix of paint to thinner, and about a 25 (or less)/75 of paint to thinner for detail work.