October Berwyn Bash! - Page 28 - Chitown R/C - Chicago's Largest RC Car and Truck Community

UE-Maxx · (#676 (**permalink**))

Since everyone is talking about what they broke I will tell my story.

Stripped carb where the HSN goes in. Cost $99.99. O.S. .18 CV-RX.

Actually its only going to be 89.99 because I have an ad # for Tower.

Firesprink, was that you with the red Jato? Not sure if anyone else had one there.

MyJeep · (#677 (**permalink**))

Quote:

Originally Posted by Revo2k

Jeez that chassis is alot! You should have checked ebay...

Yup.. might save you 50 if purchases on eBay. Emm Mayhem buggy... I might take a look and stock some up.

firesprink281 · (#678 (**permalink**))

Quote:

Originally Posted by UE-Maxx

Since everyone is talking about what they broke I will tell my story.

Stripped carb where the HSN goes in. Cost $99.99. O.S. .18 CV-RX.

Actually its only going to be 89.99 because I have an ad # for Tower.

Firesprink, was that you with the red Jato? Not sure if anyone else had on there.

yup that was me!!

Obsessive R/C · (#679 (**permalink**))

I may have trashed my Collari .30....lost the air filter on the last crash....carb is full of leaves and debris. $325.00

firesprink281 · (#680 (**permalink**))

that sucks!! did you take it apart and check the piston?

Tex · (#681 (**permalink**))

I thought the collari.30 was like $205 new???

Ponch · (#682 (**permalink**))

Either way that sucks so bad....Hope it still works, that thing ripped.

UE-Maxx · (#683 (**permalink**))

Firesprink, I was watching you drive the Jato on the pavement. Man is that thing fast.

Those weren't stock tires though where they? They looked like dirt hawgs.

firesprink281 · (#684 (**permalink**))

they are pro-line. i cant remember what ones. its one of there new tires. they are great!! i have never had a tire last so long on pavement.

SixVi6-Camaro · (#685 (**permalink**))

I think those were proline gladiators on the Jato..

http://www2.towerhobbies.com/cgi-bin...?&I=LXDX67&P=7

they are wicked all round tires.

I didn't break anyhitng that was a day ender but I did spend most of my time getting my sturr all ready to run since I didn't have tome to wrench on them much before the bash.

firesprink281 · (#686 (**permalink**))

that them!!
good call six. there is no way i would have remebered what tire anyone was running.

FreeRideFrosty · (#687 (**permalink**))

Damage fixed. It cost me $11 all together. That got me a new wing mount set ans some longer hex bolts with nuts. Good as new.

MyJeep · (#688 (**permalink**))

Quote:

Originally Posted by Obsessive R/C

I may have trashed my Collari .30....lost the air filter on the last crash....carb is full of leaves and debris. $325.00

Didn't see any air filter flying when you crashed. I like how you polished the cooling head on the collari.

PoPRC · (#689 (**permalink**))

Was it blue, with like a push down kinda of thing to get the filter element out. Had like a black plastic cage with mesh type screening? If so, somebody found it and gave it to me, and I gave it to somebody else.

MyJeep · (#690 (**permalink**))

lol .. you owe him an air filter

SixVi6-Camaro · (#691 (**permalink**))

Its a very good idea to bend up a piece of wire to hold the filter in place. 1/8 buggies don't have problems with the filter comming off during silly jumping because the body holds it from moving around but trucks the filter bangs all over the place. I have a wire on both my landmax and truggy holding the filter steady.

Here is a pic of what I did on the landmax using a Hyper 7 filter tube. the truggy is much the same but its currently using a standa