ohh yeah.. I got the Inferno GT today that replaces my out of date Kyosho Landmax 2. Basically Inferno GT is a 7.5 buggy converted to "Rally Game" as they call it in UK. Here it goes!

All stock.. It was like this for about 10 minutes..


the Old half buggy converted Landmax 2 that sports lots of hop ups and the All stock inferno GT.


15 minutes later the inferno GT was in pieces.


these are the only parts of the inferno GT that I used!


And the parts of the inferno GT I didn't use. lol!


OK After drilling holes and dremeling the JT chassis the 2 speed and fuel tank is mounted!


Rear assembly complete using the Inferno GT shock tower, body mount, and shocks only.


Front end is assembled again using the GT's shocks, shock towers, and bumper.


Radio tray and electronics all on!


and complete.. Lots of mods to get that engine mounted though. I had to dremel off the stock casted in motor mount, pull off the Massive diamater stock flywheel, Take off the pull start (too big and was hitting the Driveshaft) It was a pain but the motor sits a almost 1/2" lower than stock mounts.


And all the leftover parts!! these will go toward getting the truggy some new plastic and electronics before I sell it.


Pretty much this has got to be the most hoped up Inferno GT on the planet... lol! Also the pics don't show it but the the body on this thing is huge. body is almost 2' long and its a foot wide. Tomorow I break in the engine and get some good pics of it before I run it!


HAHA!! also just noticed that I didn't open any of the stock RTR radio gear, instructions, or tools that came with the thing.

lol..thats funny...looks great thou

schweet lookin' good

pretty sweet

Looks like a nice car man. Great job on it.

Looks cool. How long for the total buildup?

Take some pictures with the rc18t next to it for size comparison.

Looks good.

when are you thinkin youll be breakin it in? My rs4 parts should be here today or monday Ill prob have it ready to go by tuesday. lmk where is the lot you plan on heading to?

It only tok my about 4 hours from the time I opened the box to complete to finish but I do have 4 MP7.5 based RC's and can wrench on them with my eyes closed so I probably went faster than most.

I'll get a few more pics outside in a bit and get the RC18t in the pics. It will look like a spec of dust compared to the GT with the body on! lol!

I can't get out much during the week because of the odd hours I work. it will all be weekends if anyhitng. I started breakin today but now its raining on and off so I probably won't be able to do anyhitng with it until next weekend unless the weather completey changes.. (fingers crossed)
After I get it partially setup and broken in a few tanks I'll be at the BISCO lot. South side of Schaumburg in an industrial area. I suck with directions so lets try this. http://www.bisco.com/contact/ this is the place. Its a quiet place to run but cops do roll through and run plates on ocasion and talk sometimes although they have never hassled me or anyone running Rc's there other than that. If you have any good places in the area I'm up for it though!

ok here are some more pics..

Looks god John.

Looks like there are almost enough parts there to make another one... What all is needed to make a complete car?

Don't know yet. I'm going to teardown the truggy and replace some parts on that. then I'll have to do a full inventory and see whats left.

sweet! but realistically u coulda bougt some shock towers shocks and a bumper and been able to do the same thing lol

but he wouldnt have gotten the body!

no not really.. its more than body mounts and shock towers. The body alone is $96, the 2 speed trans is roughly $140 to buy seperate and right now both hard to come by. I would rather spend $400 for the RTR and sell off all the Stock RTR stuff and spare parts to make the money back rather than wait 4 months and spend $250 to get the 2 speed parts and body.