![]() |
|
|
||||
|
Here's a video of my Revo w/ the 3.3. Couple of minutes before I shot the vid, I broke a rocker arm in the rear....So I busted out hte p1's on the rear and yeah they make it ride all tall...And then a jump after the video ended I broke the P1 on the same side again....So now I get to put in my LT's!!! With the pushrods for P1,P2, and LT, how many spacers should I have on each end for the LTs? Hope y'all enjoy.
Putfile; http://media.putfile.com/Revo-33-Bashing Photobucket; http://smg.photobucket.com/albums/v3...t=000_0536.flv Ps- It's in quicktime....If you don't got it, Get it! |
|
||||
|
04-01-2006, 02:38 PM
I'll change the gearing when my thumb don't hurt so bad again. I just ripped off about half of it about 5 mins ago.
|
|
||||
|
04-01-2006, 03:06 PM
I was cutting some plastic, and it slipped and snagged the center of my nail and ripped it down meeting with the lower right corner of the nail...And it was still hangin off and I couldn't get it off, had to use nail clippers...Surprisingly it didn't hurt as much as I thought it would have though....It just hurts now because I've been typing and changed my spur gear...
Ok so what spacers if any do I need on the pushrods to run LT rockers? BTW-keep your freggin fingers outta chains duh! |
![]() |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| revo 3.3 | kevinF | |||