![]() |
|
|
||||
|
06-04-2007, 01:25 PM
OK-first-throw a small rubber band or the little ring from a balloon around the ball end and the carb throat so it stays closed when you let go of it. (no servo attached right now)
Now make sure that when the truck is off and the linkage is attached to the carb that EVERYTHING moves freely. Wiggle/shake stuff around a bit just to see if anything could possibly catch. Do you have another engine as a whole you could drop in there (running) so you could see if it's the carbeurator? Ooohhh yeah I had something like this happen, just remembered- check that your servo lead is not touching the spur gear or it may have gotten chewed up and now when it sits(not running) there is nothing making the servo short out, but when it rolls it completes the connection and goes wot. Suburban.Chicago.Rock.Crawlers
INDOOR.SERIES.CHAMPION |
|
||||
|
06-04-2007, 01:32 PM
Quote:
www.Keyknivesonline.com www.rcslot.com rc crawling headquarters and great customer support! |
|
||||
|
06-04-2007, 08:51 PM
Quote:
Suburban.Chicago.Rock.Crawlers
INDOOR.SERIES.CHAMPION |
|
||||
|
06-04-2007, 09:14 PM
Quote:
well if the carb is openeing up after he goes to idle then its NOT the carb settins, but if the carb closes completely then it could be a mixture of the high low and idle....so i would get the idle as low as you can first, then adjust the top and then the low Losi 8ight with v-spec
|
|
||||
|
06-04-2007, 09:23 PM
Quote:
ponch I think the tune is actully fine. was runnin great before. I could run tank after tank and have a consistent temp and smoke www.Keyknivesonline.com www.rcslot.com rc crawling headquarters and great customer support! |
|
||||
|
06-04-2007, 10:04 PM
futaba 3pm fm, tried a traxxas am radio and reciever AND a hot bodies tx/rx lol. I know a little overkill but I wanted to make sure It wasn't the radio. also 2 diffrent airtronics servos
www.Keyknivesonline.com www.rcslot.com rc crawling headquarters and great customer support! |