ok, all the obscenities have been omitted, so this should be real short.. I've got an OS .18TM with the T-maxx header and I have a Revo with no engine. I tried hanging the OS into the revo, only to find that it will not fit in the standard Revo mount, I have everything I need to make my revo run except the motor mount, what do I need to use here?

You need the OS Revo header.

OSMG2619 is the part number.

do'oh! I have that, along with a new pipe..

when I place the engine in the mount, the block and mount will line up on one side, but when you sneak a peak around the other side (inboard) there's a couple mm gap that absolutely will not allow the engine to mount, it looks like there is too much meat (aluminum) under the case to allow it to fit in that engine mount...

I'd rather use the OS engine, but I guess I'm going to go with the TRX if I can't make it fit without JB weld or duct tape..

Then I dunno. The 18TM is designed to be a drop in engine swap.

do you have the chassis engine mount loose so it has play? That way you can wiggle the engine in....

ummm, no!! I don't think so, the two screws that hold it were kinda tight, I'll loosen everything tonight and see if that helps...

Aren't there 2 os18tm's on the market? One for a tmaxx and one for the revo? Do you have the right one?

you've gotta be kiddin'... are there two different blocks, one for each engine?

I'm soooooo hosed!!!!


edited to add: looks like they are different, thanks!

Same crankcase part number for both engines. The different models would be for the exhaust.

But the website does say this about the Revo version:

COMMENTS:This engine differs from the TM w/T-Maxx manifold (OSMG2115) in the manner that the crankcase cooling fins are removed on this version.

Look at the OS website...the Revo version has rounded off cooling fins on the bottom of the case. The Tmaxx version has square ones. You may be getting out the Dremel.

Revo
http://www.gpmd.com/cgi-bin/wgpinf100p?&I=OSMG2112
T_Maxx
http://www.gpmd.com/cgi-bin/wgpinf100p?&I=OSMG2115

I know it sounds crazy but you will have to grind the cooling fins from the bottom of the crankcase to make it clear properly. It won't hurt anything to grind the fins off.

thanks for the help guys!!

as far as grinding the engine to fit, it's probably an option, but this actually works in my t-maxx, along with that, the engine is a year old, probably too old to race with.. I'll either go pick up the revo TM or pick up one of the TRX engines (2.5R or 3.3)...

thanks for the pics Dave...

Be sure to seal off every square inch of that engine before you start....that aluminum dust will be getting everywhere!!!!

No prob .

I'm surprised no one mentioned it earlier! That was the first thing that popped into my head when you said it didn't fit on the engine mount.

the tmaxx and revo TM's are the same excluding the header that comes with them. The headers are different hence two different part numbers for the motors.

The engine blocks are the same.

Actually, I believe that the older TMs that were for the T-Maxxes still had the fins on the bottom of the crankcase. I don't think that the newer versions have that anymore.

ive got an os 18 tm block if u want it pm me