|
|
|
||||
|
||||
|
05-31-2006, 07:37 PM
ya thats right
www.czech-it-out-graphics.com 1/29/07 never forget....TTT  Bringing old know-it-all blow hards back to reallity at a forum near you "Always Imitated, Never Duplicated" 
|
|
|
||||
|
||||
|
05-31-2006, 08:44 PM
I am getting the temps up, but that is because I am basically doing just passes at about 1/2 to 3/4 throttle.
After I slow down and pull the throttle, it bogs. I am pretty sure it is rich because there is plenty of smoke on the bottom end. Lean it an hour or two?
|
|
|
||||
|
||||
|
05-31-2006, 08:59 PM
ya lean it up, u dont want it to be too rich, a little richer than how u would race tune it. Make sure to roll the throttle and not blip it soe the bearings seat properly
www.czech-it-out-graphics.com 1/29/07 never forget....TTT Bringing old know-it-all blow hards back to reallity at a forum near you "Always Imitated, Never Duplicated"
|
 |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Break Trouble!! | NOFEARHKY97 | Racers Forum | 2 | 06-11-2006 02:38 PM |
| engine break in | SHYCAGO | Engine / Drivetrain | 12 | 03-29-2006 11:03 PM |
| revo break in? | dirtguy90 | Racers Forum | 34 | 03-06-2006 05:10 PM |
| A little photoshop work, (Im a newb to ps, gimme a break) | t to the maxx2 | Off-Topic | 35 | 12-20-2005 11:43 AM |
| how many people didn't break in there first nitro properly? | clearwaterms | Racers Forum | 17 | 02-18-2005 04:08 PM |
