|
|
|
||||
|
||||
|
Rex P5 problems -
05-02-2006, 09:58 AM
When I tighten the flywheel down, it does not spin freely, it feels as if the flywheel is contacting or rubbing the crank case. When I loosen it ,it feels okay. My vspec uses the same flywheel combo and does not suffer from this, I can move the piston easily up and down with my finger(not past the pinch)on the vspec but not on the P5. I tryed both the cone that came with engine and the one that came with the kit, both are doing the same. Did I over tighten? aren't I supposed to tighten it down? what do I do?
|
|
|
||||
|
||||
|
05-02-2006, 10:47 AM
Alright I'll try that, Thanks.
|
|
|
||||
|
||||
|
05-02-2006, 10:59 AM
Any easy way to remove the collet?
|
|
|
||||
|
||||
|
05-02-2006, 12:13 PM
Flat head screwdriver? Try to get behind it and wegde it off.
|
 |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Display problems | MX_KEVIN | Off-Topic | 3 | 02-28-2006 12:04 PM |
| If you are having problems with the site, first try this... | Mr. Tune | Off-Topic | 6 | 02-08-2006 10:48 AM |
| REX p5 | too fast | Buy / Sell / Trade | 10 | 01-27-2006 04:34 PM |
| REX p5 | too fast | Buy / Sell / Trade | 3 | 01-20-2006 10:55 AM |
| Proline RC Customer Service problems. | Traxxas_Junkee | Racers Forum | 4 | 01-10-2006 06:53 AM |
