|
|
|
||||
|
||||
|
Rex P5nx -
04-12-2006, 12:05 PM
I was looking over the instructions and noticed that Novarossi does not give any (base) needle settings, is this common among the higher end engines?
 I know that they're set on a flow bench at the factory, but some settings would have been nice when it comes time to re-tune. Any ballpark settings will be appreciated  
|
|
|
||||
|
||||
|
04-12-2006, 01:18 PM
Were settings included with the P5+?
|
|
|
||||
|
||||
|
04-12-2006, 10:40 PM
The best thing i would say is start it up and see if it will run... If it runs but the temps wont get too 200 degress lean it just a lil and wrap the head in foil or a sock...
Keep tunning till you reach your desired break-in temp. After your break in cycle is finished tune for power .... After that turn your needles and count the turns ... That would be your settings --Then follow the rules! haha!-- -Tune
|
|
|
||||
|
||||
|
04-12-2006, 11:32 PM
Thanks and thanks
|
 |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| REX p5 | too fast | Buy / Sell / Trade | 10 | 01-27-2006 05:34 PM |
| REX p5 | too fast | Buy / Sell / Trade | 3 | 01-20-2006 11:55 AM |
