|
|
|
||||
|
||||
|
Which Dremel Bit? -
02-27-2006, 12:38 PM
I want to bore down a carb restricter and need to know, which "Dremel bit" will be best for shaving a little metal off?
|
|
|
||||
|
||||
|
02-27-2006, 01:06 PM
the sanding bit.
|
|
|
||||
|
||||
|
02-27-2006, 01:44 PM
I use a flexible paper sanding disc to make holes larger by plunging the spinning disc quickly in and out of the item (think bowling ball fitting). The disc needs to be just bigger than the hole you are sanding out. You're asking about enlarging a plastic part, right?
|
|
|
||||
|
||||
|
02-27-2006, 01:51 PM
Actually I think it's aluminum http://www.helgerracing.com/j2trinit.../j2xrc8118.jpg
They go into the throat of the carb 
|
 |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I revived my Bit Clone.. :) | SixVi6-Camaro | Multimedia | 5 | 01-15-2006 02:00 PM |
| I think the Schumacher Menace has a bit TOO much power... | thenewguy821 | Racers Forum | 19 | 01-02-2006 05:59 PM |
| UE rims/racers edge foams/Bowties....Dremel (SOLD) | Tex | Buy / Sell / Trade | 11 | 07-07-2005 10:19 AM |
| What is the One Best Revo mod? | DAVEC-NITRO-RS4 | Racers Forum | 50 | 06-11-2005 09:10 AM |
