how do you do it????

i think its press RX button hold turn on truck and realease when flashing.....hold button on back of TX turn on TX release when flashing then wait for solid lights on both then its done. if im wrong someone chime in

Turn on the reciever, or w.e
hold the button till it flashes.

now while holding the button on the transmitter, turn it on, while holding brakes or w.e you want your failsafe points to be. thats the proper way at least.

well im still having the same problem it binds, works for like 2 seconds then pulses both servos wtf

thats gay

ok i tried it with different servos outside the buggy and its fine, so ill change the servos.

first part is wrong.

you have to have both receiver and transmitter off, then hold the button on the receiver, turn on the receiver and wait untill it flashes constantly, then hold the transmitter button and then turn on radio and wait till that button flashes constntly, then let go off button and wait a few seconds for the lights to be solid green.

its in the manual meatwad

lol, well thats what I meant, It might have sounded wrong.

Kevin is correct. And if you want to set the fail safe to a specific position you'll need to hold the controls in that position while turning the Tx on, and keep them there until the light turns solid on the Rx.

I generally bind mine at half brake.

Its enough to slow the buggy down without burning the servo out.